Installing a Brick Paver Walkway or Concrete Masonry Bricks

The use of Bricks or Pavers to produce a walkway or outdoor patio complements a home in a method that is unrivaled. In addition, installing a Brick or Paver pathway does not always require a pro.

The key to installing a Brick or Paver Walkway is to very first properly prepare the location where the bricks/pavers are to be installed. The location should be dug out at least a foot down, removing all topsoil and clay soil. In addition, string lines should be strung on each side of the walkway. The string lines indicate the completed height of the walkway.
When the area has been dug, 3/4" gravel stone need to be laid in and tamped down firmly. Then 2" of sand, or stone dust should be topped the gravel. Once again the sand/stone dust ought to be tamped down. Stone dust is chosen. The height between the tamped down sand and the stringline need to equate to the density of the brick or paver.

Now that you have a steady base, put a 1" pipe or ledger board the length of the sidewalk on either side of the walkway. Then utilizing a flatedge, e.g. a 2"x4" board, slide it over the two lengths of the pipe/ledger board. In doing this you will develop a level area to lay the bricks/pavers.

Now location on the level sand/stone dust strips of plastic brick borders. Install a run on both sides of the ready area. These strips will act as your pathway border and help to preserve the integrity and shape of the walkway.

You can website then begin to lay the bricks/pavers as soon as this is done. There are numerous patterns you can lay. I especially like the Herring Bone pattern. The key to laying the bricks/pavers is to guarantee that they interlock with each other. Constantly stagger surrounding rows of bricks by 1/2 of a brick to interlock them. This will once again assist preserve the stability of the walkway.

Undoubtedly bricks/pavers will require to be cut or split when developing the pathway. Unless you desire to buy or rent an expensive wetsaw, I would suggest acquiring an easy brick/paver splitter. It is basically a sculpt with a large end that is the width of the bricks/pavers. To actually cut/split the brick/paver, lay it in a bed of sand and place the chisel at a 75 degree angle over the spot where you desire to break the brick. Then using a hammer strike the butt end of the chisel strongly. You might require to do this a number of times. You might also want to turn the brick/paver over and strike the opposite of the brick using the hammer and chisle. Within a couple of strikes the brick/paver ought to break cleanly. , if your sidewalk has curves you will need to buy/rent a wetsaw.

.

After setting up the bricks, build up the outside edges with extra sand, and then shovel in the topsoil and load down firmly.
Spread stone here dust over the brand-new sidewalk and sweep into the cracks. This will complete the interlocking of the bricks and assist to eliminate any weed growth.


In addition, installing a Brick or Paver sidewalk does not necessarily need a pro. The key to installing a Brick or Paver Walkway is to first properly prepare the area where the bricks/pavers are to be set up. Now that you have a stable base, position a 1" pipe or ledger board the length of the sidewalk on either side of the pathway. These strips will act as your walkway border and help to maintain the stability and shape of the pathway. Undoubtedly bricks/pavers will need to be cut or split when building the sidewalk.

Leave a Reply

Your email address will not be published. Required fields are marked *