The use of Bricks or Pavers to create a sidewalk or patio area matches a home in a way that is unrivaled. In addition, installing a Brick or Paver sidewalk does not always need a pro.
The secret to setting up a Brick or Paver Walkway is to very first properly prepare the location where the bricks/pavers are to be set up. In addition, string lines ought to be strung on each side of the sidewalk.
As soon as the area has been dug down, 3/4" gravel stone need to be laid in and tamped down firmly. The height between the tamped down sand and the stringline must equal the thickness of the brick or paver.
Now that you have a steady base, position a 1" pipe or journal board the length of the sidewalk on either side of the walkway. Then using a flatedge, e.g. a 2"x4" board, slide it over the two lengths of the pipe/ledger board. In doing this you will develop a level area to lay the bricks/pavers.
Now location on the level sand/stone dust strips of plastic brick borders. Install an operate on both sides of the ready area. These strips will serve as your walkway border and assistance to maintain the stability and shape of the sidewalk. You can get these plastic strip borders at most home improvement shops. The strips need to be anchored down with 12" galvinized nails. You should sink these nails into the ground and through the strips every foot.
The key to laying the bricks/pavers is to guarantee that they interlock with each other. Constantly stagger surrounding rows of bricks by 1/2 of a brick to interlock them. This will again assist keep the stability of the pathway.
Inevitably bricks/pavers will need to be cut or divided when developing the walkway. Unless you desire to purchase or lease a costly wetsaw, I would suggest acquiring a simple brick/paver splitter. It is basically a chisel with a wide end that is the width of the bricks/pavers. To actually cut/split the brick/paver, lay it in a bed of sand and place the chisel at a 75 degree angle over the area where you want to break the brick. Utilizing a building bricks blocks hammer strike the butt end of the chisel securely. You may need to do this a couple of times. You may also wish to flip the brick/paver over and strike the other side of the brick utilizing the hammer and chisle. Within a couple of strikes the brick/paver need to break easily. If your pathway has curves you will need to buy/rent a wetsaw.
After installing the bricks, construct up the outside edges with additional sand, and after that shovel in the topsoil and pack down securely.
Spread stone dust over the new sidewalk and sweep into the cracks. This will complete the interlocking of the bricks and help to remove any weed growth.
In addition, installing a Brick or Paver pathway does not always need a pro. The key to installing a Brick or Paver Walkway is to very first properly prepare the area where the bricks/pavers are read more to be installed. Now that you have a steady base, put a 1" pipeline or journal board the length of the sidewalk on either side of the walkway. These strips will act as your walkway border and assistance to keep the stability and shape of the walkway. Inevitably bricks/pavers will need to be cut or split when developing the pathway.